How did it go cutting the stock? What type o saw? Backing or fill material?
I have an Edge stock I'd like to trim an inch or so. Just wasn't sure how to go about cutting it with out damaging or attaching new pad.
Great rile BTW!
I just use a good high tension hacksaw with a fine tooth blade. It’s a fairly simple operation. The stocks are filled with a high density foam from McMillan so no need to fill it with anything. I then flatten everything out with an 80 grit belt on my combo belt/disk sander. A good flat block would work too with a little extra effort. You could definitely recycle the current pad, but you’d have to grind it to fit the now smaller stock.
