Frankk,

Sounds like a worked out well and best wishes on your project.

I'd like to mention that the ABolt3 benefits tremendously if you take a file and file in a feed ramp than polish it up a bit. The Abolt3's I've worked on didn't have a feed ramp a money saving move to make the rifle less expensive I guess. I agree about the lack of support in the tang area. I torqued the front action screw Armstrong tight and am reserved on the back screw so as not to crush the support.



Trystan

Last edited by Trystan; 01/10/19.
Good bullets properly placed always work, but not everyone knows what good bullets are, or can reliably place them in the field