Originally Posted by Showdog75
I just put Talley lightweight low's on a Model Seven. Scope is a 3.5×10×40 leupold and I've got exactly 5/32" between objective bell and the barrel. I think Talley's are 1/8" increments between sizes.

Mmm... I think Talley rings go up or down in 0.100" increments. With 5/32" clearance on the front end, that should not be a limiting factor to drop down to super lows. However, going to super lows may present an issue with the amount of fore and aft movement of the scope to adjust eye relief. Or, interference between the Talley LW bases and the scope itself. The set up below, I had to file a relief notch on the rear base to clear the power adjustment ring, and a chamfer on the front base to clear the objective bell. But, it fits, and the scope is "there" when I mount the rifle...

[Linked Image]