Customs are way too expensive for me.
I bought $25 in steel. $20 to ship.
About $60 for abrasives and epoxy, don't have it yet.
Needed pin stock. $16 for a tube of brazing rods. (Cheaper than buying pin stock, but will make a lot of 1" pins)
Cheap calipers for scribing. $16
Sandpaper, flap wheel for grinder, new file. $50
Nope, no way I could afford one of those rich dude customs.
Hell, those things cost $150-200.
Look at what I'm saving.
And I don't even have a knife yet!
I will build one myself.
It cheaper that way.
