Just lost a Magnus black hornet in my reinhart target. The insert came out when I pulled the arrow. I can feel it when I push an old carbon arrow into the hole. Tried driving it out with the arrow and a mallet but it just slips past. Does anyone have a trick to get this thing out without destroying the target. It is 9 inches into the 15 inch target.
A couple of thoughts...
1) Rigid wall tube, maybe an arrow shaft, with borescope inside to guide/align it. Retract the borescope, and drive out the broadhead.
2) Cut the target in half, or even part way. Then use banding straps to put the two halves back together. Maybe there is a good adhesive as well, but if you strap the two halves together, I bet that would be sufficient. Not unlike a layered foam target.
Jason
