Can be a long or short process depending. I should create a flow chart for what I do.
I always start with a proper bullet for intended purpose.
Pick powder for velocity goals. Sometimes I want velocity, sometime it does not matter..
Pick primer for said combination. Ball, stick, small, large volume.
Set seating depth based on bullet and purpose. Hunting C&C start at 0.030, monos at 0.050. Target at 0.005-0.010.
Shoot trial loads and go from there.
Velocity not there, change powder.
If groups are showing inconsistent ignition, change powder or primer. ie widely variable chrono readings or fliers.
If load is showing promise, tweak seating depth. ie consistent chrono readings, symmetrical groups, just too large.
