Until one goes off through the shop wall and into the neighbors house, killing a kid. I get sick and tired of hearing about you stupid fu cks doing this. Yes, check your brass for fit. You should never have to check your loaded rounds unless you have no concept of how to set your dies or know where the lands are. What you guys are doing is a rookie move. Not a great suggestion
Ok Karen. Make sure you wear your mask too. If it troubles you so, remove the firing pin first, or have someone do it for you.
Good Lord, no wonder this country is being run by binary people.
One question, would you feel comfortable with your self-proclaimed gun expert neighbor checking loaded rounds with a rifle pointed at your kid’s bedroom wall? I wouldn’t. Mechanical things happen. Pins drop.
To the OP, learn how to measure headspace on YOUR chamber, full length size your brass to control the shoulder and base or you’ll fight it, end up with clickers, and ruin your brass in a few firings. Pop the primer out before measuring a fired piece of brass or it’ll give false readings.
