I just saw your request Shawlerbrook.

When John (Mule Deer) showed his bench supported setup I just had to make one.

I had an aluminum box I made for another purpose so I did some mods and it works great. I did have to make a plywood clamp on extension for the front of the NRA style concrete bench at our range to get the unit out in front so the rifle could sit in the normal place on the bench.

The rear knob is used to get the sensor parallel to barrel. Aluminum plate is threaded for elevation shaft with locknut. The hole in the side of the sensor was enlarged slightly for a bolt that goes into a tapped hole in top of the shaft. To change elevation the top bolt is loosened so elevation shaft can be rotated without spinning sensor.

[Linked Image from imagizer.imageshack.com]