Originally Posted by Mackay_Sagebrush
Originally Posted by aboltfan
I've used the rings that came with the T3 on seven rifles with complete success. The only change I make to them is that I replace the factory screw rings with new screws from the hardware store. I also use a screw from my scope rings screw kit to make a stop for the rear ring.

I've had no issues or scope slippage with them. These were ideas picked up from other members and they have worked.

This.

I have used the factory rings a number of times, only replacing the ring screws with hardened steel screws instead of the soft aluminum Tikka factory screws. A small amount of medium loctite or clear fingernail polish hardener on the threads and torque them evenly using an inch pound torque wrench and you are not likely to ever have an issue.

Same experience here

drover

223 Rem, my favorite cartridge - you can't argue with truckloads of dead PD's and gophers.

24hourcampfire.com - The site where there is a problem for every solution.