S&W wheel gun?
Easiest trigger job ever!
I use Arkansas stones. Just slick up the bearing surfaces and lube slightly. Trigger pull will be slick as glass.
I NEVER trim the hammer return spring and always tighten the hammer strain screw fully.
Mess with either spring and you can throw ALL the timing off and may cause misfires.
Agreed, if you don't know what you are doing, and what part does what inside the revolver.
My competition action jobs on S&W's were a bit more complex than that. They were fine tuned. Even double action, you knew exactly when the hammer would fall. Almost like shooting single action.
