[quote=RHClark] ... Do not cut carbons to length and expect them to shoot perfect. Youu need to start full length and bare shaft tune cutting as little as 1/4" at a time.
....
Thank you! I would have cut them to length if you wouldn't give us the warning. What kind of cutting tool do I need to cut them to length/to let them shoot perfectly?[/quote
I always had use of a professional arrow cutting tool but I've been told a Dremel would work. I always bare shaft tuned, cutting from the nock end.
One other thing. Shoot lots of bare shafts only using the average as an indicator. Any inconsistency will affect them so much you don't need to cut after just a couple shots. Also always confirm your evaluation by adding or taking away tip weight, this will prevent a false reading from an arrow bouncing off the riser.
When I was shooting competition no one cared if they had an inch or three inches of arrow sticking off the shelf at full draw.
