I've sworn for years that I'd never sell this rifle. This is a Remmy 700 in 7mm Express (280 Remington) that has been
Cerakoted in a custom "midnight bronze" finish and placed into an unbedded
McMillan Hunter's
EDGE. Standard 13.5" LOP including 1" Decelerator pad. Two stainless swivel studs. Rifle has a
Timney trigger that is niiiiiccee. This rifle is an absolute hammer. ROUTINELY provides 0.5-0.6MOA accuracy with factory Federal Trophy Copper ammo. The first group I ever fired with this rifle and that factory ammo was 0.6" at 100 yards. The largest group I've ever fired with this rifle/ammo is 0.87"at 100 yards and I've fired sub-1" groups at 200 yards. I've saved a few of these targets and will gladly send them with the rifle. I'll also include
three boxes of the Trophy Copper ammo the rifle likes so well.
That's the good. The bad is purely cosmetic. Before the rifle was Cerakoted, the sight holes were filled in. When the Cerakote applicator prepped the metal for finish, the filler in those holes was disturbed somewhat. The very front hole was almost cleaned out. I stuck a Remington filler screw in there to plug the hole and went forth shooting as described above. Small cosmetic issue, as stated, but want to disclose that fully. You can see all of this clearly in the pics below.
If you want a no-BS, no-hassle, no-time-wasting, and no-risk shooter, this is it. $1750 + $25 shipping.
Scope not included.
IF the rings have been lapped to this receiver, I'll throw them in
for free. If not, I'm keeping them. Thanks for looking.