Hello all, well I finally decided on a barrel contour, length and twist for my second rifle build, I ended up going with a heavy 28" 1:18 / 8 groove Mcgowen with a straight taper. It is coming along and I think I am going to be happy with my choice of barrel. Still needs a lot more work on the stock and finish work on the metal.The target is in 1/2" squares. I have somewhere around 160 hours in the rifle so far. There is still a ton of work to be done if you look closely the stock is still about 2.75" thick and still needs shaping. As for the target it was only to check the scope mounts and to check the adjustments of the scope, the 4 shots on the left were mine starting on the bottom with shot #1 and checking the scope adjustments for what they were doing to poi, the 2 rounds on the left were my son-in-laws, all just to be shooting the rifle and checking the action for functionality other than the proof loads. the whole rifle will have to be disassembled, finish work on the metal and stock done, bluing and stock finish applied. Once that is all done I will start work on load development. Right now I have 3 molds, 2-405 gr and 1-500 gr and have cast and powder coated 20 or so of each to start out with.So what does everyone think so far.
[img]
[img]https://s19.postimg.org/xz3lyqy0f/IMG_0319.jpg[/img] [/img]