|
|
|
|
Joined: Aug 2010
Posts: 477
Campfire Member
|
OP
Campfire Member
Joined: Aug 2010
Posts: 477 |
Is it possible to open a McMillan Edge inlet for ADL to BDL. It has that very flat ADL bottom which doesn't carry well in hand, figure a BDL floorplate would round the stock out a little better. Seems like all that should need to be done is cutout the area for the trigger guard, glass bed a little and maybe repaint as needed. Am I missing anything? Will this reduce the structural integrity of the stock?
If you died tomorrow, what would you have done today ...
|
|
|
|
|
Joined: Apr 2005
Posts: 13,777 Likes: 6
Campfire Outfitter
|
|
Campfire Outfitter
Joined: Apr 2005
Posts: 13,777 Likes: 6 |
Edge stocks have a very thin aluminum pillar reinforcing the action screw holes and a escutcheon for the front action screw. I'm not sure you can inlet it without removing/drilling out those pillars. I removed them on a couple of edge fill stocks when I added M5 DBM. It took a bit of the fill out with it but it was ok in my case because I was replacing it with thicker pillars and bedding.
|
|
|
|
|
Joined: Mar 2005
Posts: 5,234
Campfire Tracker
|
|
Campfire Tracker
Joined: Mar 2005
Posts: 5,234 |
Never done an edge tech, but have had a few standard McMillans sent back to the mothership and done without issue.
|
|
|
|
|
538 members (1badf350, 2500HD, 1941USMC, 219 Wasp, 1lessdog, 1minute, 51 invisible),
2,445
guests, and
1,351
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
Forums81
Topics1,193,898
Posts18,518,425
Members74,020
| |
Most Online11,491
Jul 7th, 2023
|
|
|
|
|
|
