I have a like new condition Tekonsha P3 proportional brake controller with all of the mounting brackets and hardware, the generic wiring pigtail (virgin/never used) and the optional and on plug-n-play wiring harness for Toyota and Lexus vehicles. I know this harness fits a 2010-2013 Tundra and believe it does a 2007-2009 as well.
It’s perfect, less than a year old, and still has the film over the display. Only selling it because I traded trucks into an F-250 and that has a built in brake controller.
Asking $130 shipped for the controller and everything w/ both harnesses included.
These are the Mercedes of the brake controllers for the Tundra. I had one in mine and I liked the adjustability of it for pulling trailers. Simple plug and play and initial setup for your trailer.
Writing from the gateway to the great BluMtns in southeastern Washington.
Just remember, "You are the trailer park and I am the tornado". Beth Dutton, Yellowstone.
These are the Mercedes of the brake controllers for the Tundra. I had one in mine and I liked the adjustability of it for pulling trailers. Simple plug and play and initial setup for your trailer.
Agreed. And ESP out of California sells a dash faceplate adapter for mounting. No need for drilling holes to install
I mounted mine in the cubbie hole in the bottom middle of the dash. Drilled a hole for the wiring and pushed it in there. Never moved. Only drawback is using the manual brake lever on the bottom, you can do it but you have to know its there.
Writing from the gateway to the great BluMtns in southeastern Washington.
Just remember, "You are the trailer park and I am the tornado". Beth Dutton, Yellowstone.