Home Forums Gear Free Classifieds 9mm +P Predator Defense Hard Cast Flat Point

Friends,

I have available some heavy hard cast +P loads for the 9mm. These are 148 grain hard cast flat points. They run 1,100 FPS from a Glock 17 in testing. These are heavy penetrators. The brass is new Starline and will be shipped in either MTM or Berry's 100 round plastic ammo boxes.

Price includes shipping and insurance.

It is $105 for 100 rounds to your door, which after S&I works out to about $40 per box of 50.

* No, I don't sell them in boxes of 20. The shipping (not to mention packaging) is so costly that it makes no sense to do so.





Shipping goes UPS Ground insured. You have to be 21 since it is handgun ammo. Will only ship to places where legal and it is your responsibility to know your local laws. No shipping to restricted states or jurisdictions.

Post the amount you want followed with a PM, so I can keep track please.

I have 1,500 rounds of this available as of today.

Are these good in a Sig 365 or S &W Shield? Too hot?

100 rounds please. PM incoming

I'll take 400 rounds. Please PM payment details

I’ll take 100

KUDU,

I ran the last batch through a Gen 1 shield with no issues. Approximately 150 rounds. The majority of the testing was done using a Glock 19, a G17 and a G34, along with a CZ 75. The CZ was used due to CZ's reputation for notoriously short chambers. If ammo will run through a CZ on one end of the spectrum, and multiple generations of Glocks on the other, chances are good, it will run in most modern guns in proper working order. It is always advisable to have a fresh recoil spring when shooting warm ammo, as it is cheap insurance and it reduces wear on your frame (frame battery) at a minimum.

I cannot comment on suitability for a Sig 365, as I do not have one for testing purposes. .

The Sig P365 is plus P rated. I intend to shoot the ones I just purchased through my P365.

I have fired maybe 30 rounds of the very similar Buffalo Bore “Outdoorsman” 9mm round through a Ruger LC9, no problems.

Heck, come to think of it, the people at Buffalo Bore chronoed it through an LC9.... 1,021fps

https://www.buffalobore.com/index.php?l=product_detail&p=388

I’ve shot a couple of magazines of the Buffalo Bore +P Outdoorsman rounds out of my P365 with no problems. Buffalo Bore now charges $33.11 for 20 rounds and their shipping charges also are expensive, so the OP’s offer sounds like a great deal.

tag

This is a great deal for top quality ammo

This ammo uses the same projectile. From Rimrock bullet company of MT (unless something has changed, which can and does happen from time to time).

Same velocity range.

Just a one man shop though. Trying to keep the overhead as low as possible and find the most practical/economical ways to produce, as it is beneficial for everyone.


The real challenge is trying to source primers that are not outrageously priced. That is a major issue right now.

I'll take 100. PM on the way.

TAG

I will take 200. I will send the $210 to the same address as before. I will PM you a different address to ship these to, rather than what you used for the 10mm.

Thanks,

Dean

I will take 200 if have them still?

I will take two hundred at $105 per hundred.
Please PM me where to send the funds.
Thanks, Gary

Any idea how these would perform in an LCR 9?

I'll take 100. PM incoming.

100 for me