Home Forums Hunting & Shooting Hunting Rifles Ruger M77’s

The 77 always seems to come up in these type of discussions. Same dislikes and likes. Heavy, investment blah blah, Accurate enough, bad barrels, etc…. Working mans gun, accurate, sleepers, so on and so. Seems like everyone has had a bad one if you have had enough. I’ve only seen one that wouldn’t shoot. Compact mkII in 7mm-08 when I was younger.

I’ve owned enough to know a few tricks that might have tightened it up.

I’ll go ahead and post what I know up. Most folks will already know these but I think this is a good time to share. Isn’t that why we are here?

Stop reading here and PM me if your Ruger is a price of junk and you want to mail her to me because it’s a lost cause.

1. Torque the action screws in order. front lug screw gorilla tight, rear trigger guard monkey tight and middle just enough to hold it firm and allow the floor plate to latch without being rattly.
2. Relieve the box magazine contact points where the trigger guard and floor plate hinge meet. Should have the ability to move just freely and not bind when action it torqued. (See step 1)
3. Most Ruger triggers are adequate when it comes to weight and creep except the MKII. (Now notice I said adequate, no need to argue over it. There are better factory triggers) All have creep and over travel that will drive you crazy when compared to other triggers but can be corrected with trigger job or new trigger. The MKII needs some serious stone work to ease the weight and creep. (Maybe the root cause of a lot of inaccuracies). Easy enough for the novice with patience and directions found online.
4. I’ve never bedded or floated a Ruger so I cannot speak to that. Others can chime in on that front.
5. To reduce the weight. Stay away from the magnum contours and 25/06, buy a new lighter stock, or a set of dumbbells and bulk up a little. If a 7-9 lbs rifle knocks you out of the hunt maybe it’s time for a new hobby or life choices. Meant to be a joke. The magnum contoured barreled guns and 25-06 are tanks!
6. Sell them to me a severely discounted rate since, you know, the above issues.

My love for the Ruger 77 came from my first 2 and my uncle. A Stainless MKII 308. Given to me by my father in 2001 (my first bolt gun), a m77 tanger in 30-06 given to me by my father in law, and a 25-06 skeleton that I obsessed over ever since my uncle showed me his in the 90s. I still own all three, plus a Hawkeye Blue and laminate 264, and a stainless mkII 300 wsm.

Cheers all! And long live the Ruger M77!

The '70's 77's have bolts that lock down with the safety on, which I prefer. My 7mm RM has a bolt that doesn't lock down. I guess the change was made for safety reasons, but I don't like it.

Did it have a trigger job or a timney installed? This is the Mark II correct ? If so the safety selector pad was ground too far down, it should lock. Good luck with the repair, it involves sending it back to RUger who will undo the trigger job and replace the safety selector . Ask me how I know.

Ruger 77 is the Timex watch of the rifle world.

Did Ruger ever make a M77 in a bull barrel? Over 22 inches?

I love this very informative thread.