Current factory pos recoil pad
Btdt....
Their is a cure for that pad.
Cut rectangle with Dremel thru inside flat steel mold liner just under the hard plastic.
Pry up with screw driver to cut off with exacto knife.
Now the fun begins once you get the inside exposed.
Start digging out the inside of it on shallow angle with bent needle nose pliers, dental picks, Dremel debriders, shallow bent clothes hangers heated up with lighter.
π€¦ββοΈπ€¦ββοΈπ₯΄π₯΄π₯΄π₯΄π€¦ββοΈπ€¦ββοΈ
Wunderbar....
After about 2 days of 4 to 5 hrs digging , feeling , pulling out tiny bb sized to pea sized chunks of rubber if ya can get the little SOB,s the further in you get, you have a hollowed out mossberg recoil pad that works and has 1/4 to 1/2 walls 360Β° all around it that appear perfectly normal to eye.
And it actually works.
( never again will I do this)π€¦ββοΈπ€¦ββοΈππ€¦ββοΈπ€¦ββοΈ
BTDT on a walnut stocked 930 dove gun I had several yrs ago.
Did a thread on that entire project with " pics or it never happened " also.
Buy the limbsaver pad man.
Trust me ..
I schit you not.....
ππ»ππ»ππ»