Home Forums Gear Free Classifieds looking for: 6x47 (6x.222 Rem Mag) dies and .222 Rem Mag brass

Please let me know what you have and a price.

I know this might rule some of you out, but Paypal is my only means of sending a pymnt in a timely manner.

Thanks.

I have a reamer, Redding dies and about 1000 new brass. I’ll count tomorrow and get back to you . The brass is all RP new

Thanks!

I have used brass I can sell if you decide you want to go that route. I know I have RP and some Herters and could shake loose several hundred.
I've got a penchant for .222 Mag. rifles and have accumulated a lot of brass over the years.
If I don't hear from you I'll assume you went the new brass route.

tag

Since I don't anneal, I am hoping to start with new brass. Thanks.
Bobby

Are you having a new single shot barrel spun up? I really like my 6X47 and it absolutely loves 70 grain NBT bullets.

I think I know where a 6X47 Rem. 40X is.

I'm looking at a used Contender barrel right now, but if that doesn't pan out, I may go ahead and sell my 6.5 BRM and get one built.

What powder are you loading in yours?

H335 has been what has provided best results. I use TAC in my 6X45 and it should work well in the X47. NBT is what I shoot the most of, but 70 grain Sierra BK is just as good. I have a 12 twist barrel and anything over 70 grains must be a flat base or my groups open.

Thanks. I ran H335 almost exclusively for years in several 6-.223s, but I'll likely give TAC and CFE223 a whirl.

The. Noslerbrass is cheaper than I Paid for my RP brass