Home Forums Hunting & Shooting Muzzleloaders Ultra Bore Coat update!!

Doug - is your site down?

I already coated all my center fire rifle bores.

I coated all but one of my shotgun bores. I have a fairly expensive 30" 10 gauge barrel for my Remington SP-10. I use it for turkey hunting exclusively. I fired 20 rounds as fast as I could load them to cure it. 1st cleaning got the remaining UBC and powder fouling. Went shooting again the next weekend, firing approximately 15 shots. Tried to clean it but there was no plastic and no powder fouling. I also shoot a tungsten alloy which is a lot harder than the barrel steel. It ain't harder than the UBC. I took the barrel off and I couldn't even see any streaks from the tungsten - it streaks and scratches bores terribly if you don't use a really stout wad. I did clean it by running a Hoppie's #9 soaked patch wrapped around a nylon brush. Waited 10 minutes and pushed a dry patch through wrapped around the brush again. I got one small 1/4" long black streak. I'll never have to clean that barrel again.

The Gun-Shield can also be used on those expensive hydro-transfer patterns to protect them from...everything. I had Doug & Co coat my rifle stock, and they apply two coats of the Gun Shield as part of their service; I applied 3 more coats. Amazing stuff...simply amazing.

So if I need to Bore Coat 10 muzzleloaders is there a bigger container of this stuff I can buy? Doug, pm me if you would.

Thanks,

Don

Nope you are most likely trying to find the old website. Go to
www.dynamicfinishes.com look under Dyna - Tek.

Doug, change your sig line then!

Thanks I just did that.