i did some lee 170gr flat nose .308 bullets today, the mould is actually .309. I just put some bullets in a plastic drink cup and sprayed in some of the autozone vtech block engine paint and rolled them around. Put them in the oven and when they started to set up, pulled them and sprayed again. Actually that worked and they came out at what i expected at .311, or two over the .309.
I think i could probably run them as is, but tomorrow gonna put the gaschecks on them and see about bringing them back down to .309.
I tried some of the harbor freight red, and didn't like the results.
one issue is with these skinny 308 bullets and with the gas check design is needing to have a block or something to hold them.
