Thanks Mule Deer, I forgot to mention that is what I did and it was around 35 pounds on my cheap torque driver. So I figure it was between 35 and 40 pounds. But this is from me tightening it down when I took it a part to open the barrel channel about 20 years ago and then again to install the trigger. I didn't realize then that over or under tightening the screws can really change accuracy. So I either know more or I worry to much. LOL. In retrospect if it was shooting well before it will probably shoot well again at the same torque or as close my cheap wrench can achieve. I was mostly just wondering if the correct specs were quite a bit higher than what I had it torqued at. I don't think it would be lower. The Swedes sure made some nice rifles. Thanks again.
