Originally Posted by Steve Redgwell
I make my own as well. I'm a minimalist. This is the template for my CF targets. I get 500 printed at Staples on fluorescent green paper. The fluoro-green works in dull, foggy conditions as well as sunny. It is not fatiguing to stare at and is easily located.

The thin outer cirle is 5.5 inches in diameter. The black dot is 3 inches. I use these for scopes and iron sights.

[Linked Image]

The only thing that I've done to them over the years was remove the area at the bottom where I used to record load data. I also made the outer circle thinner and narrowed the iron sight block at the bottom of the circle..

I modded them because I found that I was saving the group and not the whole sheet. I cut out a small square with the info written beside the holes.

These were my older ones.

[Linked Image]


Interesting. That big black circle would be too big for my liking... Hard to be precise with that set-up. But hey, if it works for you...

Originally Posted by raybass
I try to stick with the basics, they do so well. Nothing fancy mind you, just plain jane will get it done with style.
Originally Posted by Pharmseller
You want to see an animal drop right now? Shoot him in the ear hole.

BSA MAGA