7/8" Do-It-Best Hardware rubber leg tip, shaped down. Has a good matte look.
1" fit ok but looser on the "shaft" when the thin 'band' with the markings on it was intact. The 'band' spun right off. This is very snug. Original o-ring seems fine and sorta fills the gap between the rubber and the 'housing'. Took a couple shots to get the length desired.
A 7/8" vinyl leg tip may work without sanding, just trim it, however, it would protrude about 1/8" more due to the domed shape that can not be sanded flat like the rubber. I dug around a fairly well stocked hardware store and that's what I could find. I would have black-tapped the bugger if I had too. I wanted it gone and well, it's gone.
7/8" Rubber leg tip Like this:
Cut tube. Cut brass post. File slot. Clean up. Sight in. Cap it.
