Gunner, I ordered right from K&M. Basically you'll need an expander mandrel, hand cutter with 284 stud/cutter and an adapter that I can spin the case with my cordless drill.

Here's the stud that goes into the hand tool. You can see the cutters on the end.

http://kmshooting.com/carbide-cutting-pilot.html

Here is the hand tool and shell holder set up.

http://kmshooting.com/steel-pilot-carbide-cutter-power-adapter-and-shell-holder-1023.html

The handle comes right off the shell holder assembly, then you can attach the drill motor right to it. I back the outside neck cutter all the way off. You shouldn't have any reason to outside turn at all.

Give them a call though. They will get you set up right. Good folks to deal with.

Last edited by beretzs; 07/23/17.
Semper Fi