Originally Posted by DakotaDeer
Originally Posted by savage62
I WAS THINKING OF A REDUCE LOAD FOR THE 270 WINCHESTER FOR A SIERRA BULLET 130 GR. WITH 26 GR OF 4350 IMR .I JUST DON'T LIKE THE 26 FROM 52 BEEN USING JUST ASKING GUN NUTS


I've run a lot of loads of 36 grains of IMR4198 through a 270/130 combo. It works great.

For even less recoil, 13 grains of Red Dot.


36 grains of 4198 is what I found when I dissected a couple of Rem's Managed Recoil loads
in 270.. but I think they were using a 110 grain bullet instead...Sierra's...

but then again, that is a great load, if you need more range than the 30 grains of 4198 give ya...

I like the 30 grain load, as it is an easy number to remember, works on about any cartridge from
243 and up and bullet weight isn't an issue...

its easy on the brass for we handloaders also...

and either's accuracy is more than most folks would believe as they only usually buy it for their kids..

"Minus the killings, Washington has one of the lowest crime rates in the Country" Marion Barry, Mayor of Wash DC

“Owning guns is not a right. If it were a right, it would be in the Constitution.” ~Alexandria Ocasio Cortez