I didn't get any leading with the bullets before I started PC'ing them so leading was never a problem, I just like the powder coat for long-term storage over traditional types of lube. The Lyman clone has always shot well for me in my Ruger BH, the 45 bullets is a new mold for me it cast HP's, cup points or FN bullets depending on which pins I install in the mold.
I've been shooting the Lee 200 grs. SWC bullet out of my Hi-Point carbine PC'ed at a little over 1K fps. haven't chronoed the HP or Cup points but I'm sure they are fairly close to the same velocity. I had to make a slight POA adjustment visually to compensate for the slight drop of the heavier bullet but once I did that they all fell into place at about 30 yds.
[img]
https://i.imgur.com/of1HS3y.jpg?2[/img]
