Originally Posted by iddave
RH,

Here are a couple of pictures I snapped of my set-up last night. These are "medium" Mountain Tech rings btw. I tired the "low" rings and while they JUST cleared the barrel on the objective end, but the bolt handle was hitting the eye-piece on the back end. I suspect that is a function of the Talley two piece bases sitting considerably lower than most pic rails.

[Linked Image]

[Linked Image]

Maybe the eyepiece is smaller on the Nightforce than the LRHS and will allow you to run the lows. If so, I suspect scope caps will be out of the equation.

Dave


Thanks a bunch Dave. With the MT lows,was the bolt hitting the scope ocular ,not allowing you to use that scope at all,or just hitting your rear scope cap?