Home Forums Hunting & Shooting Ask The Gunwriters Magnetospeed on Rock rest

Clean setup JB!

I also have been working on a rest for the magnetospeed.

This is the simpliest only required opening up two existing holes.One on the magnetospeed where the strap bolt goes through to 1/4" and the other one opening up one of the offset holes on the quick release plate to 1/4". This is on a manfrotto fluid head. Center bolt is removed.

If there is an issue it might be leaning over bench to get the height correct when range is hot not sure how easily that can be done.





Also working on a platform to sit on bench similar to yours JB. Issue there is that the rifle will have to be moved to rear of bench and not sure range rules will allow it.

One experiment has a few magnetic base dial indicator offsets with three rods so magneto speed can be attached to front rest and extended the correct amount forward of the bench. The last connector has a small bolt and nut for magnetospeed. The offsets allow for a wide range of adjustment.