casting is a craft in it's own right. you can get bullets you can't buy anywhere, and size them to fit your specific guns. it's not for the impatient. i started to be able to afford to shoot, with a single cavity lee mould using a pot on a camp stove.
start with one mould and when you start getting a good result, go on to another. what works in one mould may not with another, temp, casting technique etc. there are a lot of helpful sites, but the one i have found most helpful has already been mentioned. cast boolits! also let me tell you , there are lots of ways to flux, just be sure you do it from your scrap so you start with a clean mixture.
wolfe publishing has a good book...casting 101 i think is the title. it is a good resource.
Last edited by wahoo; 01/01/21.
