Or you can blow the aluminum cap out the top of the die with a compound press.
Don’t ask how I know.
My learning curve damage was covered by Lee CS.
DF
You adjusted the die down too far into the press.
I guess you found out it's best to thread the die in, raise a case into the die and resize. Then try hand seating a bullet into the case mouth. If it slides in, tighten the collet die down 1/8 of a turn, repeating until the case mouth is small enough.
When the die came out, myself and others emailed Lee about that. All we heard were crickets.
![[Linked Image from i.imgur.com]](https://i.imgur.com/AP39Jhm.jpg)
