Originally Posted by callnum
Originally Posted by deflave
Buy a 12' sliding, compound miter saw and stand. Sell it when you're done.

Inside corners get coping cuts, anybody that doesn't do this isn't white.

If you can't use a coping saw, don't hang trim.



I see this method in starter homes and trailer houses.

All high end homes get precise miters


Doubtful- corners on sheetrock are never square because of the taping and mud to finish to the corner fills in the corner. Can't put a 90 degree mitered baseboard corner into a rounded corner and make it look finished. I know lots of finish carpenters who do high end houses and all of them cope their corners....

Never underestimate your ability to overestimate your ability.