It seems no matter what I do, the firing pin is the same or less. I measured it as best I could with my calliper using a point low on the bolt as a base and it seems it sticks up about .025-.030. Adjusted the firing pin by screwing it in a little and a lot but no significant difference. In fact, I screwed it in a couple of full turns and it barely dented a primer. I mean it barely left a mark, much less a dent. Then I backed it out to near where I thought it should be (just less than flush with the back of the bolt) and 50% of the rounds fired. What should I do at this point, give it to a smith or send it to kimber???
