If you're going to use it in its current specs, you might consider buying the alloy bottom metal sold by CVMW. The plastic/nylon trigger guard assemblies are probably the worst part of the whole 600/660/600Mohawk design.
The point of contact is Willie Manning at 541-396-6246.
Coquille Valley Machine Works
54511 Arago-Fishtrap Road
Myrtle Point, Oregon 97458
JEff
Great point! I inherited a mint 660 in 6.5 RM some years ago. The plastic floorplate was developing a slight bit of a perch belly after years of pressure against it from the magazine spring. I relaced it with the alloy floorplate and put the original on the shelf in the safe. IIRC the part was around $100 then.
I had the recall trigger/safety work done also as the 660's are still covered under the recall. I think the alloy floorplate dresses up the rifle a bit too.
