Home Forums Lever Action Central Lever Actions - General BLR owners - scopes?

What scopes and ring setups are you BLR owners using?
Pictures of your rings would be much appreciated.

I have a Leupold VX-1 2-7 with Leupold mounts. I've thought of throwing a Trijicon1-4 Accupoint I have on it with maybe some Talley's but never have, these always worked fine for me.

That looks pretty good.
What height mounts are you using? Looks like you could go even lower.

I used Warne



https://www.24hourcampfire.com/ubbt...lr-warne-weaver-style-bases#Post15901564

I have a leupold vx-2 2-7x33 in weaver bases and the original style low rings. I tried talley lightweight lows but they were still to high for a good cheekweld. With the weaver setup it's just right

my favorite BLR is a S.S.Laminate stock take down 30-06 i did have a 3 x 9 Leupold but change to a Leupold 6x -42 because this 6x is proven to hold zero better . i use Weaver steel base and rings on this BLR rifle also

Lows, I don't think I could go much lower with that front sight.

Same here, 2x7x33 Leupold VX2, Weaver bases and low rings. I took the back sight off because the scope was so low.

That's exactly what I plan to do.
I hadn't thought about the front sight being in the way, as M1Garand pointed out.

Leupold VX-2 Talley Steel QR Lever rings on my pre'81 .358 Win.

I have the same scope with Weaver mounts

Which Weaver bases and rings? Looks like there's several options.

I like the 1.5-5 Leupold on most any rifle:

The rings are extra low. I don't know the part number on the bases. I did run into an issue on ordering bases for my BLR 81'. I was going to swap over to Burris steel bases and rings and ran into something about "round top" and "flat top" receivers on BLR's. I did some research and thought I had it figured out but when I received the bases from Burris they didn't lay flat on the top of the frame. The part I ordered had a little arch to it and there was a slight gap under the base and over the top of the frame. At the time Burris didn't have the other style, the flat one, and I gave up on it and went back to the Weaver set up.

I use a Vortex Diamondback 1.5-5x32 and a Dednutz one piece mount.

Dan

Bushnell 3200 1.5-4.5x scope with Warne detachable rings and a Weaver base. Sits atop a pre-81 in 358 Win. It was my primary Blackbear gun for 20 years.

My .358 wears a Zeiss 4x32 in Leupold mounts.

When I owned a M81 in 308 WIN I used one of the Redfield 3-9x40mm USA-made scopes as re-introduced by Leupold. Mounted it in standard Weaver 2-PC bases and old style Weaver rings - never moved under recoil and I didn't want the long one piece base down the top of the receiver.

Leupold FXII 2.5x20. Talley bases and Talley QD rings (with screw option instead of levers) on my then-new BLR in .358 Win. Same set up on my BLR '81 Lightweight in .308.

That's a good-looking combo ^^^.
Let's see that sling also - it looks interesting.