Home Forums Reloading Big Game Rifles Case Mouth Straightening

I use a Lee Collet die on new brass.

Lee makes nothing but Dog Schit and I'd not compromise a string affixed to a Duck Decoy with one. Hint..............

As expected, the sucker takes the bait.

Hint .........

SuperKchunt,

Rest assured,that your STUPIDITY isn't "bait",but rather a plight and them differences are beyond "stark"...you "lucky" kchunt. Hint. Congratulations?!?

Pardon my simply shooting it all then some,while you set on the sidelines of Life,hoping to not schit your pants. Hint.



Fortunately for you,Imagination and Pretend are free,so even YOU can "afford" to "contribute" by Pretending aloud. Don't "forget",that Imitation is THE most Sincere form of Flattery. Hint.

Fhuqking LAUGHING!.............

What just happened?

SuperKchunt likes to Pretend,that her STUPIDITY is on purpose. Hint.

She's never even "seen" a sound rifle,let alone "shot" one,but "gets" to Pretend aloud. Hint.



Coming full circle,headspace control is paramount and starts with Virgins. FL fhuqking that up,is VERY fhuqking funny schit. Key on EVERY rifle,is to make a headspace determination,then feed it Virgins that control same. Hint.

To make schit easy,exactly what rifle are you working with and exactly what brass. Hint.

Just sayin'............

You've been hijacked.

Facts reliably hurt TENDER Feelers. You'd do well to simply shut the fhuqk up,take notes and apply same. Hint.

Just sayin'..............

Larry the dink strikes again

Fortunately for you and your ilk,Whining is free...you "lucky" kchunt. Hint. Congratulations?!?

Pardon Splendid Wares that exist,while you "reload" colored water in your SuperSoaker. Hint.




Fhuqking LAUGHING!............

😂🤣

Well, most understood the question......

I use the rounded sides of needle nose to make em round enough to poke in a die. Even badly squashed one's can be saved.

I typically just size the necks with a fl die or use a bushing with expander for virgins but had a batch recently with more run out then I would like. Not sure if it’s the die or something else. Is NSO’d neck sizing OD as in no expander?

Thanks

LOL ... The Great Alaskan Hobbit got had.

Nice salmon coloured AIRSOFT pew pew. Did you get that from one of your pards for Valentine's Day?

Laughing ........

Larry’s lookin for his hair piece

Use a pick or a punch or a plier to get it back to close then FL size and rock on. You might want to anneal if they have not been before.

I use a carpenter's Nail Set to round collapsed necks. It is a cheap, readily available tapered punch.

I usually run the expander through the neck to get uniform neck tension. If they’re dented too much for the expander to enter the neck, I use a tapered punch to open them up.

300 H&H, 35 Whelen and 375 cases get bumped up a bit and then sized to the original diameter just enough to give slight resistance on chambering in order to establish a good shoulder.

Skied up there a couple of times. Great snow!