|
Joined: Dec 2003
Posts: 26,107 Likes: 1
Campfire Ranger
|
OP
Campfire Ranger
Joined: Dec 2003
Posts: 26,107 Likes: 1 |
Getting ready to buy a gas powered pressure washer for cleaning up around here. Its' largest job will be cleaning the concrete every couple years or so and smaller jobs will be to clean brick on the house and wood on the back porch, probably when I do the concrete. Other than that it may be used a few times a year to spray mud or salt out from under the truck or something along those lines. I was set to buy one that is rated at 3200 psi but was doing some reading that says that much pressure may be very hard on the mortar in the bricks, so now I'm thinking about one in the 2500 lb area. What would you do? What have you done and what was your experience?
Thanks.
Those who are always shooting off at the mouth usually aren't shooting straight. Build a man a fire and he’ll be warm for a day. Set a man on fire and he’ll be warm for the rest of his life. www.wvcdl.org
|
|
|
|
Joined: Nov 2015
Posts: 15,222 Likes: 23
Campfire Ranger
|
Campfire Ranger
Joined: Nov 2015
Posts: 15,222 Likes: 23 |
|
|
|
|
Joined: Mar 2021
Posts: 2,463 Likes: 5
Campfire Regular
|
Campfire Regular
Joined: Mar 2021
Posts: 2,463 Likes: 5 |
my Hotsy Shark is rated at @ 4000 psi IIRC... also has a regulator to lower pressure... i just leave it wide open and back away a bit for delicate stuff... more is better IMO...
|
|
|
|
Joined: Jul 2006
Posts: 4,855 Likes: 3
Campfire Tracker
|
Campfire Tracker
Joined: Jul 2006
Posts: 4,855 Likes: 3 |
Get one somewhere around 2800-3000 psi and just use the wand tip with the widest spray pattern that comes with the machine and stand back a bit until you see how things are going.
"Men must be governed by God or they will be ruled by tyrants". --- William Penn
|
|
|
|
Joined: Feb 2006
Posts: 1,416
Campfire Regular
|
Campfire Regular
Joined: Feb 2006
Posts: 1,416 |
I suspect most of those numbers are assigned in the marketing departments much like the HP ratings used to be. If you could test them they would not meet the ratings.
A unit with about a 5 HP motor will easily do what you are describing. The risk of damaging things depends more on how close you hold the nozzle than the ratings.
If you don't use it very often remember to run it out of gas before storing it and don't store it where it might freeze.
Jerry
Minnesota; Land of 10,000 Taxes
|
|
|
|
Joined: Jul 2020
Posts: 3,948 Likes: 1
Campfire Tracker
|
Campfire Tracker
Joined: Jul 2020
Posts: 3,948 Likes: 1 |
Throw GPM into the equation.
Higher pressure without the flow to back it up is meaningless.
I finally figgered that out, and it’s amazing what the higher flow will do for you.
|
|
|
|
Joined: Oct 2021
Posts: 10,937 Likes: 4
Campfire Outfitter
|
Campfire Outfitter
Joined: Oct 2021
Posts: 10,937 Likes: 4 |
Getting ready to buy a gas powered pressure washer for cleaning up around here. Its' largest job will be cleaning the concrete every couple years or so and smaller jobs will be to clean brick on the house and wood on the back porch, probably when I do the concrete. Other than that it may be used a few times a year to spray mud or salt out from under the truck or something along those lines. I was set to buy one that is rated at 3200 psi but was doing some reading that says that much pressure may be very hard on the mortar in the bricks, so now I'm thinking about one in the 2500 lb area. What would you do? What have you done and what was your experience?
Thanks. You’ll have (should have) a selection of nozzles that come with the unit. With one you can literally drill a hole in concrete and others provide a softer pattern. The distance from the nozzle to the job being done matters a lot.
|
|
|
|
Joined: Aug 2014
Posts: 5,052 Likes: 8
Campfire Tracker
|
Campfire Tracker
Joined: Aug 2014
Posts: 5,052 Likes: 8 |
Working in the oilfield I have a lot of hours using a pressure washer. I liked high volume at moderate pressure better Than low volume high pressure.
|
|
|
|
Joined: Dec 2013
Posts: 44,652 Likes: 22
Campfire 'Bwana
|
Campfire 'Bwana
Joined: Dec 2013
Posts: 44,652 Likes: 22 |
Get one somewhere around 2800-3000 psi and just use the wand tip with the widest spray pattern that comes with the machine and stand back a bit until you see how things are going. I've got a 3300 Honda I got on sale at Sam's for $349 that does everything I need it to do. Just either back away or use a wider spray tip for more delicate jobs. I personally have never changed the tip on mine.
Slaves get what they need. Free men get what they want. Rehabilitation is way overrated. Orwell wasn't wrong. GOA member disappointed NRA member 24HCF SEARCH
|
|
|
|
Joined: Feb 2009
Posts: 2,439 Likes: 4
Campfire Regular
|
Campfire Regular
Joined: Feb 2009
Posts: 2,439 Likes: 4 |
Can always turn it down….cant turn it up.
|
|
|
|
Joined: Jun 2011
Posts: 85
Campfire Greenhorn
|
Campfire Greenhorn
Joined: Jun 2011
Posts: 85 |
Whatever you do, I recommend a Honda motor and a Cat pump. The Honda because of the infrequent starts. I don't use TrueFuel beacuse I $18 for a gallon seems ridiculous, but non-ethanol and fuel stabilizer is your friend. I usually prime mine, but I rarely have to pull more than 3 times. No non-Honda I had was anywhere near as easy to start even with the same care and I don't buy el cheapo stuff, so I am a Honda believer. I have no evidence other than anecdotal, but my Cat pumps have always lasted. I ended up with a Dewalt from HD because it was on sale. I think it was $500 to $600. It came with different nozzles and the poster who said one will eat concrete and he is right. Don't ask.
Regards,
Kris
|
|
|
|
Joined: Jun 2011
Posts: 85
Campfire Greenhorn
|
Campfire Greenhorn
Joined: Jun 2011
Posts: 85 |
Whatever you do, I recommend a Honda motor and a Cat pump. The Honda because of the infrequent starts. I don't use TrueFuel beacuse I $18 for a gallon seems ridiculous, but non-ethanol and fuel stabilizer is your friend. I usually prime mine, but I rarely have to pull more than 3 times. No non-Honda I had was anywhere near as easy to start even with the same care and I don't buy el cheapo stuff, so I am a Honda believer. I have no evidence other than anecdotal, but my Cat pumps have always lasted. I ended up with a Dewalt from HD because it was on sale. I think it was $500 to $600. It came with different nozzles and the poster who said one will eat concrete and he is right. Don't ask.
Regards,
Kris
|
|
|
|
Joined: May 2020
Posts: 2,645
Campfire Regular
|
Campfire Regular
Joined: May 2020
Posts: 2,645 |
I've owned 4 or 5 over the years and now own a Dewalt 3300. Does everything I need it for. Whatever you do , heed the advice here and do not under any circumstances let the women folk use it! Trust me , they will fry your pump!
|
|
|
|
Joined: Sep 2014
Posts: 593 Likes: 3
Campfire Regular
|
Campfire Regular
Joined: Sep 2014
Posts: 593 Likes: 3 |
GPM in most cases trumps PSI.
|
|
|
|
Joined: Dec 2005
Posts: 9,587 Likes: 1
Campfire Outfitter
|
Campfire Outfitter
Joined: Dec 2005
Posts: 9,587 Likes: 1 |
id go to lowes,homedepot,harbor freight,northern tool,tractor supply and buy one at 2800 -3000 psi and use it until it dies . no need to spend a fortune. northern tool has extra hoses,extension hoses and about any other acc you can think of at good prices.
just make sure you drain it good before winter
Last edited by srwshooter; 04/09/24.
|
|
|
|
Joined: Dec 2008
Posts: 574
Campfire Regular
|
Campfire Regular
Joined: Dec 2008
Posts: 574 |
heat and good soap are much more important then pressure.
|
|
|
|
Joined: Mar 2009
Posts: 4,421 Likes: 2
Campfire Tracker
|
Campfire Tracker
Joined: Mar 2009
Posts: 4,421 Likes: 2 |
GPM in most cases trumps PSI. Look for higher GPM.That is what will get the job done a lot quicker.
~Molɔ̀ːn Labé Skýla~ As Bob Hagel would say"You should not use a rifle that will kill an animal when everything goes right; you should use one that will do the job when everything goes wrong."Good words of wisdom...............
|
|
|
|
Joined: Jul 2009
Posts: 5,184
Campfire Tracker
|
Campfire Tracker
Joined: Jul 2009
Posts: 5,184 |
I bought a Husqvarna Model JDX268 (made in Japan) that was on sale at Costco online with free shipping. I don't remember the price but was cheaper than anything I could find anywhere else that was comparable.
It is rated at 3200PSI/2.5 GPM and it idles real slow until you pull the trigger and it starts spraying. If I'm worried about damaging something I just move farther away. It will use a gallon of soap quickly so you have to keep an eye on the soap level.
|
|
|
|
Joined: Aug 2021
Posts: 497
Campfire Member
|
Campfire Member
Joined: Aug 2021
Posts: 497 |
I farm and ranch so I got a monster which you don't need but make sure you release the pressure every 30 seconds or so if you go electric.
|
|
|
|
528 members (163bc, 204guy, 1lessdog, 1minute, 1badf350, 10ring1, 67 invisible),
2,552
guests, and
1,196
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums81
Topics1,193,785
Posts18,515,843
Members74,017
|
Most Online11,491 Jul 7th, 2023
|
|
|
|