What could I expect to pay a competent(someone who can do it right the first time) gunsmith to have a barrel recontoured? Actually, what I really want is to have a couple of my rifle barrels turned down about .020"-.030'" along the entire contour of the barrel( just thinned a little).
Next question:
How much to fill some mis-aligned iron sight holes on one of the above barrels and drill and tap again straight; also cut off an inch or two on this tube and recrown?
Please respond only if you have first-hand experience with this kind of work and know of, or are a competent gunsmith that would like to take on this project.
Redneck, here on the campfire, comes to mind as I write this.
One of these rifles is a stainless Rem 700 and would need to be re-blasted to the original finish on the barreled action, the other with the iron sights is a Win 70 and is going to be Cere-coated after the metal work is done.
Redneck or Mickey Coleman or anyone who knows of someone else that can do this please respond.
I'm not tough to please, I just want it done right and am willing to pay but want a fair price too.
There aren't any smiths around my locale that I can trust.
Thanks in advance, Leftybolt
Last edited by leftybolt; 04/11/08.