|
Joined: Feb 2008
Posts: 1,653
Campfire Regular
|
OP
Campfire Regular
Joined: Feb 2008
Posts: 1,653 |
Looking to replace my factory laminate on my Rem 700 Mountain Rifle in 7mm-08 and would like some advice before making my choice.Go with the B & C Alaskan TI or the Alaskan II.I really don't want to mess with their mountain rifle version due to the fact I that the fit is often horrible.
|
|
|
|
Joined: Feb 2007
Posts: 7,932
Campfire Outfitter
|
Campfire Outfitter
Joined: Feb 2007
Posts: 7,932 |
McMillan Edge. The B&C stocks with the full bedding blocks are heavy and will likely weigh about the same as your laminated wood stock. www.stockysstocks.com lists them at 28-30 oz. My Edge 2 stocks weigh 21 and 23 oz.
Most people don't really want the truth.
They just want constant reassurance that what they believe is the truth.
|
|
|
|
Joined: Dec 2004
Posts: 5,978
Campfire Tracker
|
Campfire Tracker
Joined: Dec 2004
Posts: 5,978 |
McMillan Edge. The B&C stocks with the full bedding blocks are heavy and will likely weigh about the same as your laminated wood stock. www.stockysstocks.com lists them at 28-30 oz. My Edge 2 stocks weigh 21 and 23 oz. I can tell you this with 100% certainty since I mill laminated stocks almost every day- and weight them. There is no way a B&C stock- even one with a bedding block -will weight as much as a laminate wood stock does if they are both the same design. Having said that, the B&C stocks are heavier than a McMillan Edge. So are most glass stocks - including regular fill McMillans. The "Faux Ti" ALaskan I stocks that Stocky's markets only have pillars installed- they don't have the full bedding block. Real world weights on those are only about 4 ounces more than a comparable sized full finished Edge, if that.
Last edited by jim62; 03/30/11.
To all gunmaker critics- "It is not the critic who counts; not the man who points out how the strong man stumbles, or where the doer of deeds could have done them better. The credit belongs to the man who is actually in the arena.."- Teddy Roosevelt
|
|
|
|
Joined: May 2006
Posts: 4,062
Campfire Tracker
|
Campfire Tracker
Joined: May 2006
Posts: 4,062 |
My vote: stocky's number 2950/51 Mountain Rifle Models - - Short or Long Action ADL only. (22-24 oz.)
“There is no limit to the amount of good you can do if you don’t care who gets credit.” R. Reagan
|
|
|
|
Joined: Jan 2011
Posts: 1,127
Campfire Regular
|
Campfire Regular
Joined: Jan 2011
Posts: 1,127 |
Looking to replace my factory laminate on my Rem 700 Mountain Rifle in 7mm-08 and would like some advice before making my choice.Go with the B & C Alaskan TI or the Alaskan II.I really don't want to mess with their mountain rifle version due to the fact I that the fit is often horrible. ADL or BDL? Both Alaskan stocks have a magnum barrel contour and work okay with a standard sporter, but would be a stretch for a mountain barrel. You probaly should go with the 2950 mountain stock if you want ADL, or they just came out with a BDL mountain version. But, it has the full aluminum bed for some reason. I was shocked at how many original Ti takeoffs are lying around when I posted a want to buy. I had several PM's and a few of them were new stocks. Good luck.
|
|
|
|
Joined: Feb 2007
Posts: 157
Campfire Member
|
Campfire Member
Joined: Feb 2007
Posts: 157 |
Be advised - while Stocky's lists the AKII at 28-30 oz. Mine showed up a few weeks ago at 35 oz. And as mentioned above, the channel will be way too open for a MR barrel contour. i'd go with the mountain version even if it requires some fitting.
|
|
|
|
Joined: Jun 2008
Posts: 355
Campfire Member
|
Campfire Member
Joined: Jun 2008
Posts: 355 |
I got one of Stocky last BDL 2950/51 with pillars but no bedding block to replace the wood stock on my .280 Mountain rifle. It dropped right in and it was correct for the slim contour barrel. It changes the feel of the rifle.The wood stock had most of the weight in the butt but the 2950 is light in the butt making the rifle balance alot better. I also have an Alaskan T2 without the bedding block on a standard BDL. It's ok but not as nice as the 2950.
|
|
|
|
Joined: Feb 2007
Posts: 7,932
Campfire Outfitter
|
Campfire Outfitter
Joined: Feb 2007
Posts: 7,932 |
I actually have one of the 2950's on a stainless ADL MT rifle. It should have been a straight drop in, and would have been if B&C had drilled the action holes straight. Since it has no aluminum bedding block it is the only B&C stock that feels trim and is fairly lightweight. They will also be the easiest of any synthetic stock to break since they have very little support.
I haven't actually weighed one of the laminated mountain rifle stocks, but it is a pretty trim piece of wood. I'd bet there is not much difference especially since many of the B&C stocks seem to be a bit heavier than they advertise.
Most people don't really want the truth.
They just want constant reassurance that what they believe is the truth.
|
|
|
|
Joined: May 2006
Posts: 338
Campfire Member
|
Campfire Member
Joined: May 2006
Posts: 338 |
I purchased a S.C./FN Model 70 Win EW .300WSM a few months ago. I like the rifle, and it is apparent that quality work is being performed on the new Model 70's. The action is very smooth, feeding is excellent, and it has the claw extractor. I have taken care of the MOA trigger with a lighter trigger spring and maximum let out of the trigger spring screw. However, the B&C stock has got to go. No disrespect to those of you who like the B&C stock, but to me it is FAT. I thought I could get used to it, but to me it feels too large for the rifle, especially in the grip and forend. I hope to put a McMillan Super Grade style with Ultra Lite Edge Tech on it sometime in future.
Fellas 2 Unless you have large hands, I would seriously consider a McMillan stock. To be totaly honest with you, I now wish that I had shelled out the extra money and purchased a Sako 85 Finn Lite ST in .300WSM. Hopefully this will help you in your selection.
G2
|
|
|
|
Joined: Sep 2004
Posts: 29,383
Campfire Ranger
|
Campfire Ranger
Joined: Sep 2004
Posts: 29,383 |
I would go Edge Mountain Rifle if it were mine. You are going to have a sizeable barrel gap with the Alaskan TI.
|
|
|
|
611 members (1beaver_shooter, 160user, 10gaugemag, 1eyedmule, 10Glocks, 1badf350, 49 invisible),
2,444
guests, and
1,333
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums81
Topics1,191,834
Posts18,478,050
Members73,948
|
Most Online11,491 Jul 7th, 2023
|
|
|
|