If you index it properly a guy could take advantage of all the "up" in his scope. That is if he had enough "down".
Sure.. But keep in mind this isn't known until the other end is done.. I.e., the barrel would have to be marked, then turned around, set up again in the lathe and about half the job might have to be done over..
The .015 is edge/edge, meaning (obviously) that the bore is actually only .0075 off dead center.. That should equate to only about a couple clicks on the scope knobs. The owner made a note - said he'd keep this in the file and if the barrel won't shoot he'd replace it and pay for the install..
I'll know shortly.
