Originally Posted by Brad
Originally Posted by JamesW
I also bed the scope mounts to the receiver using JB Weld. I use Teflon spray on the receiver, bolts and bolt holes, clean the bases then apply epoxy screwing them down into a neutral position (not torqueing them). When epoxy set I then take out the screws and use blue lock tite and torque.


For me the point is to epoxy it all into a monolithic mount, screws, bases, receiver... all of it.


Sounds good to me! Have not considered using JB weld to make a monolithic mount to receiver, actually been trying to avoid this happening! I use it to bed and take up imperfections, too scared I will never be able to get it apart!