Some OCD questions from someone who likes to verify what may be obvious.
About how much diameter does the coating add? My first attempt at coating will be with some 250 grain .38-55 bullets that drop from the mold at .377 and are being sized to .3765" in a custom order Lee sizing die. Even if coating makes them .378 before sizing I'm guessing that running them through the die won't scrape off any powder coating? I mean, they're going to be shoved at 1600-1800 fps down a .375" groove bore so I figure a trip through the sizing die won't hurt but wanted to verify.
Does that coating make it much harder to add gas checks?
In your first pic in this thread, would you call that a teaspoon size; table spoon size? Looks like you're using a typical large yogurt size plastic container of about 24 ounces, if not what size is that?
By weight, what would you say is in that spoon - 1.245 ounces or maybe 1.317? Okay, just kidding on this last one, I'm a precise kind of guy but not quite that bad...
Will probably come up with more questions as I go about this but thanks for a good tutorial on getting started.
