Thought I'd put it out here.
Heard I should focus on 1340 or 1440, 2" spindle bore, easily set to cut common tpi pitches, precision... Might consider a starter unit as my dream machine is outa sight. Would make best sense for DT-5 in the long run maybe. Advice, leads, piss'n match, PMs, or insults welcome.
Sven (inside joke)
"I can't be canceled, because, I don't give a fuuck!"
--- Kid Rock 2022
Holocaust Deniers, the ultimate perverted dipchits: Bristoe, TheRealHawkeye, stophel, Ghostinthemachine, anyone else?
| 
