And it set the shoulder back on my cases about .010" more than I needed....with RCBS dies.
Case stretch, of course, was a quick killer of case life.
Then you set it to deep, set the die deeper than needed to chamber in your rifle, do it to see if you can turn it down far enough to see ifn it works..
if the die won't go down any more and it won't cam over either. start over.
Get your cases to chamber if possible don't use em yet, then back off the die just so it chambers, then turn down a bit more.
Check headspace with any kind of device that fits over the neck and butts up about midway on the shoulder, lots of things work for this.
He's got a bolt action, he can set it pretty tight.
I"m with Hanco if I'm having problems like this BS get SB dies. you will like em if you use military brass a lot.
