I’m looking at the basic 550.
I just want to size and bell on the press, then prime and dump powder outside of the press, the seat and crimp on the press.
Not the way most guys do it, but a better “fit” for me.
Plus I don’t have to buy their dies.
The SDB would give you volume handgun, and a LEE Classic Turret would give you on press/off press rifle cartridge operations for a lot less money. But it is two presses. The SDB requires both sides access whereas the LCT just needs left-side access.
I load 9mm, 40sw, 45acp, 44mag on my SDB and a number of different rifle cartridges on my LCT.
My setup:
https://sites.google.com/site/hobbyhintstricksideas/home/reloading-bench
