Hondo,
Being the kind of guy who won't take no for an answer, I contacted CH4D and got a .240 Wby case sizing die. It uses a shell holder without the slot, essentially a flat platform to push the case into the die. A rod is used to tap the case out. It take a lot of pressure to swage a 25-06 case into a .240 case, as the belt is formed by squeezing the case body. There is usually a ring of sheered brass to be pealed off the newly formed belt. The process doesn't fully form the shoulder and fire forming is needed to complete the new case. These cases chamber easily in my rifle, as compared to the cases I tried to make using a .240 Wby FL sizing die.
Looks good so far. I haven't loaded or shot any yet, but will post photos of the whole process when I get it completed.
Whether it's worth all the effort. I'll report, you decide...
DF
