|
Joined: Aug 2008
Posts: 10,443
Campfire Outfitter
|
OP
Campfire Outfitter
Joined: Aug 2008
Posts: 10,443 |
When you clean your AR, where do you clean? Do you completely disassemble the bolt? If you were to do a complete cleaning, where do you grease/lubricate? Is it safe to tear down your bolt and lube the gas rings? Honest questions. My brothers AR is FILTHY and needs a good scrub. Is this a good lube to use? Mil-Comm TW25B
30-06 till i die, the greatest round ever! I carry a gun because a cop is too heavy! CEO of a Turdlike People: Turds & Tats Division... (per Ingwe )
|
|
|
|
Joined: Dec 2009
Posts: 3,395 Likes: 2
Campfire Tracker
|
Campfire Tracker
Joined: Dec 2009
Posts: 3,395 Likes: 2 |
I don't. Unless to remove sand or other foreign debris, they get cleaned when the barrel gets replaced. If needed due to the above, pull the BCG out separate the bolt, spray everything down with brake cleaner, wipe quickly if necessary, lube with wheel bearing grease and reassemble. Properly built AR's will go thousands and thousands of rounds without cleaning as long as they are lubed. Somewhere just over (maybe just under) 3k rounds without cleaning- 4k-4.5k, would have to look to be sure, but same/same. No cleaning just lube. Both work guns, both ran without issue until the barrels were replaced.
|
|
|
|
Joined: May 2007
Posts: 14,653
Campfire Outfitter
|
Campfire Outfitter
Joined: May 2007
Posts: 14,653 |
I usually clean mine once a year, just because. I bring all my guns to the parts washer at work and do it there.
I scrub out the upper, pour some parts cleaner down the barrel and push a patch down it. I disassemble the BCG and scrub it and replace the spring in the bolt. Then I dry it all out with compressed air and lube it.
I use Mobil1 for oil.
I haven't heard of the stuff you linked, but for $53 / 8 oz. it better be made out of bald eagle feathers and unicorn tears.
your flippant remarks which you so adeptly sling
|
|
|
|
Joined: Oct 2009
Posts: 2,934
Campfire Regular
|
Campfire Regular
Joined: Oct 2009
Posts: 2,934 |
I get the unicorn tears but wouldn't the bald eagle feathers possibly jam the action?
|
|
|
|
Joined: May 2007
Posts: 14,653
Campfire Outfitter
|
Campfire Outfitter
Joined: May 2007
Posts: 14,653 |
The fish in their diet increases the viscosity coefficient of the lubricity.
your flippant remarks which you so adeptly sling
|
|
|
|
Joined: Jan 2005
Posts: 57,494
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2005
Posts: 57,494 |
same as others.... CLP is still what I use for lube... I'm stubborn but it works...
I've shot with folks taht have shot out barrels easily without major cleaning.
We can keep Larry Root and all his idiotic blabber and user names on here, but we can't get Ralph back..... Whiskey Tango Foxtrot, over....
|
|
|
|
Joined: Aug 2008
Posts: 10,443
Campfire Outfitter
|
OP
Campfire Outfitter
Joined: Aug 2008
Posts: 10,443 |
Thanks guys.
Is it safe to lube the gas rings in the BCG though?
30-06 till i die, the greatest round ever! I carry a gun because a cop is too heavy! CEO of a Turdlike People: Turds & Tats Division... (per Ingwe )
|
|
|
|
Joined: Nov 2005
Posts: 6,168
Campfire Tracker
|
Campfire Tracker
Joined: Nov 2005
Posts: 6,168 |
I am sure my AR's are the cleanest weapons I own, I clean them the same way I cleaned my 16 in the service 30 years ago. Bolts apart and all carbon removed and oiled before they go back in the safe.
The collection of taxes which are not absolutely required, which do not beyond reasonable doubt contribute to public welfare, is only a species of legalized larceny. Under this Republic the rewards of industry belong to those who earn them. Coolidge
|
|
|
|
Joined: Dec 2014
Posts: 31
Campfire Greenhorn
|
Campfire Greenhorn
Joined: Dec 2014
Posts: 31 |
LSA is the only lube you'll ever need. You can get a quart here for $8.00 and the can will last a lifetime. While the whizbang lubricants may work, their cost is criminal. When considering alternative lubricants like wheel bearing grease or motor oil, ask yourself why it's called wheel bearing grease or motor oil before you put it on your rifle.
|
|
|
|
Joined: Jan 2005
Posts: 57,494
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2005
Posts: 57,494 |
Thanks guys.
Is it safe to lube the gas rings in the BCG though? What I clean every few hundred rounds is pull out the BCG, put a drop in the holes for the rings, wipe it off with a rag, wipe out the inside of the upper, and then put CLP on my finger and wipe it inside the upper, then a drop or so on all contact surfaces of the BCG and spread it then, and put it back together.
We can keep Larry Root and all his idiotic blabber and user names on here, but we can't get Ralph back..... Whiskey Tango Foxtrot, over....
|
|
|
|
Joined: Nov 2011
Posts: 31,069 Likes: 4
Campfire 'Bwana
|
Campfire 'Bwana
Joined: Nov 2011
Posts: 31,069 Likes: 4 |
I.E, after a range trip, at a minimum, I'll pull the BCG, make sure the bolt is clean and lubed, hose out the inside of the barrel extension with some brake clean or shooters choice to insure it's free of grit, and that everything is well lubed when I put it back together. Generally I'll run a couple of patched down the barrel as well, but usually they don't take much to come clean.
You didn't use logic or reason to get into this opinion, I cannot use logic or reason to get you out of it.
You cannot over estimate the unimportance of nearly everything. John Maxwell
|
|
|
|
Joined: Oct 2014
Posts: 4,755
Campfire Tracker
|
Campfire Tracker
Joined: Oct 2014
Posts: 4,755 |
Agree, they don't need nearly as much cleaning as some claim. After few range trips I'll usually hose the bolt down with WD-40, then blow it off with compressed air (don't leave it wet on the bolt to dry and gum up). That takes off most of the fouling, with minimal effort. Re-apply some gun oil, and put it back in the receiver again. I don't strip the bolt apart unless it needs repair.
The one part I hate cleaning is the flash hider, after using foaming bore cleaner in the barrel.
Gotta say though, regardless how often it does or doesn't need cleaning, I'd be embarrassed to own a rifle with rust all over it, as shown above.
|
|
|
|
Joined: Aug 2007
Posts: 115,424 Likes: 13
Campfire Sage
|
Campfire Sage
Joined: Aug 2007
Posts: 115,424 Likes: 13 |
When you clean your AR, where do you clean? Do you completely disassemble the bolt? If you were to do a complete cleaning, where do you grease/lubricate? Is it safe to tear down your bolt and lube the gas rings? Honest questions. My brothers AR is FILTHY and needs a good scrub. Is this a good lube to use? Mil-Comm TW25B Cleaning an AR is just silly. If you have a few thousand through it, and bump into a parts cleaner, take it apart and throw all that schit in there. You can lube your ring. It won't hurt anything. Never clean another person's gear. That's called enabling. That is all. Dave
Trump being classless,tasteless and clueless as usual. Sorry, trump is a no tax payin pile of shiit. My young wife decided to play the field and had moved several dudes into my house
|
|
|
|
Joined: Jan 2005
Posts: 57,494
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2005
Posts: 57,494 |
Agree, they don't need nearly as much cleaning as some claim. After few range trips I'll usually hose the bolt down with WD-40, then blow it off with compressed air (don't leave it wet on the bolt to dry and gum up). That takes off most of the fouling, with minimal effort. Re-apply some gun oil, and put it back in the receiver again. I don't strip the bolt apart unless it needs repair.
The one part I hate cleaning is the flash hider, after using foaming bore cleaner in the barrel.
Gotta say though, regardless how often it does or doesn't need cleaning, I'd be embarrassed to own a rifle with rust all over it, as shown above. That one with a bit of rust on it, probably shoots better than a lot of folks guns... knowing the competition side of it....We had to shoot in rain etc.... I'd much rather worry about how my gun shoots, and who cares what it lookslike. Looks are for vanity. Vanity doesn't win matches or shoot tiny groups.
We can keep Larry Root and all his idiotic blabber and user names on here, but we can't get Ralph back..... Whiskey Tango Foxtrot, over....
|
|
|
|
Joined: Jan 2010
Posts: 2,621
Campfire Regular
|
Campfire Regular
Joined: Jan 2010
Posts: 2,621 |
I use to clean and lube after almost every shooting session. The only thing I do now is add a few drops of oil now and then and run a patch or two down the barrel. Once a year or so I might do a detail cleaning and good barrel cleaning, if I have the time.
Last edited by wareagle700; 01/21/15.
John 8:12 "I am the light of the world. Whoever follows me will never walk in darkness, but will have the light of life."
|
|
|
|
Joined: Oct 2014
Posts: 4,755
Campfire Tracker
|
Campfire Tracker
Joined: Oct 2014
Posts: 4,755 |
I'd much rather worry about how my gun shoots, and who cares what it lookslike.
Looks are for vanity. Vanity doesn't win matches or shoot tiny groups.
It's not about looks, it's about taking care of your stuff. If it's rusty there, where it wouldn't take half a thought to apply a little gun oil, where else is it rusty? I don't polish my guns and baby them, but there's a difference between using it hard and outright neglect.
|
|
|
|
Joined: Jan 2001
Posts: 18,080
Campfire Ranger
|
Campfire Ranger
Joined: Jan 2001
Posts: 18,080 |
Since using a suppressor with all of the associated crud, I carry a tall can of spray on Rem-Oil and just keep spraying it wet w/o getting it on the bolt face. A shot before shooting last a good while.
When I can't take the grime I strip it like basic training.
Mike
God, Family, and Country. NRA Endowment Member
|
|
|
|
Joined: Dec 2009
Posts: 3,395 Likes: 2
Campfire Tracker
|
Campfire Tracker
Joined: Dec 2009
Posts: 3,395 Likes: 2 |
It's not about looks, it's about taking care of your stuff. If it's rusty there, where it wouldn't take half a thought to apply a little gun oil, where else is it rusty?
I don't polish my guns and baby them, but there's a difference between using it hard and outright neglect.
Ok. Can you tell us about your hard use with M4's?
|
|
|
|
Joined: Sep 2009
Posts: 13,860
Campfire Outfitter
|
Campfire Outfitter
Joined: Sep 2009
Posts: 13,860 |
I've seen a well-used MARSOC M4 or three and they are rust-free. Just sayin'. They will walk up to you and close YOUR dust cover.
|
|
|
|
Joined: May 2007
Posts: 14,653
Campfire Outfitter
|
Campfire Outfitter
Joined: May 2007
Posts: 14,653 |
I've seen a well-used MARSOC M4 or three and they are rust-free. Just sayin'. They will walk up to you and close YOUR dust cover. Sigh
your flippant remarks which you so adeptly sling
|
|
|
|
576 members (12344mag, 10gaugemag, 16penny, 1badf350, 007FJ, 1Akshooter, 56 invisible),
2,466
guests, and
1,264
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums81
Topics1,193,049
Posts18,500,981
Members73,987
|
Most Online11,491 Jul 7th, 2023
|
|
|
|