The Work Sharp does create a slightly convex edge. Basically you are removing metal against a slack belt. The hard side of the fixture is opposite the side being ground. Might be a bit of a learning curve doing an axe head though.
I could probably make up a couple "Work Sharp" 120 grit Ceramic belts for harder than heck steel. ------A fringe benefit of my part time job. I may have to try that twist on some M4 at 63/64 Rc although aluminum oxide seemed work ok on that . Tim
"The significant problems we face cannot be solved at the same level of thinking we were at when we created them." Albert Einstein
At Khe Sanh a sign read "For those who fight for it, life has a flavor the protected never knew".
|