I have a #3 in 223 that will group right at an inch with some handloads. It really likes the factory Federal 50 grain red tip varmint loads.
Have a #1 in 338wm that will shoot factory Barnes ammo just under an inch consistently, but handloads are a crap shoot. Still haven’t figured that one out and too lazy or cheap to buy Barnes bullets. This may get rebarreled or sent down the road as I have really have no need for a 338wm. May be a good candidate for a 7 PRC project.
Have a #1 in 6mm CM. Was a 7mm mag, but had PacNor put a new barrel on it. It will consistently shoot 1/2” groups. This has a local gunsmith made speed hammer and Jard Trigger. I have not had the hanger drilled and tapped yet for a set screw, but considering it.
