Sweet , so how was the grind? Any learning curve?
Only difference it's twice as fast. Thin material with high grind height is made for flat grinders. Never made many hunters with 3/32 because you run out of material hollow grinding.
Touch it on that disc after most of your grind. While still using the 50 or 60 grit. You will find out how really flat it is.
I asked about the disc because every time that belt goes over that platten that joint will make it different. A disc is truly the only flat ground way.
I figure that's why you don't see many as ground finishes. I had no ripples thus far so all have been 400grit polished.